Construction items
Design and construct instrument pod mount
Design and construct antenna bracket
Design and construct GPS bracket
Add side brackets to rudder pedal mount
File control stick to improve aft travel
Investigate and free up LH suspension binding
Double-loop the suspension bungees
Instrument panel
Get the airframe anodised
Paint the drag struts
Get the drag struts, instrument pod, tail & control tubes professionally painted
Corrosion-protect drag struts
Add/modify joystick grip with PTT switch
Swap out electric pre-rotator & install recoil unit
Get the seat mounts, cheek plates, etc, anodised
Get the rudder pedals powder-coated
Rivet rudder pedals
Find remaining AN3-7A bolt for the seat mount
Tidy up the seat mount with diagonal fairing cuts
Fabricate tubular spacers for drag-strut brackets
Tidy up seat edges / paint
Upgrade tyres
Acquire padding for shoulder belts
Reshape leading edge of stabilisers
Epoxy fin/stabiliser bolt holes
Offset tail
Rudder control horns
Rudder cable pulleys
Voltage regulator mount
Battery mount
Mount rotor tach
Install radio antenna
Mount strobe
Mount landing light
Torque & locktite engine bolts
Wiring harness
Master alarm